Wire colors for Genie Lamp cable supplied with the Parts Kit
The cable has four conductors → ||||
White – – used for our ground wire. This ground may be made under the
coach, under the dash, or under the utility hood. Strictly a matter of
choice and convenience, as long as it is a good chassis ground.
Red – – to hook to the Light Switch – – the pressure switch that is under
the coach near the actuator – – this wire is pre-connected to the red Genie
indicator lamp on the dashboard end of the cable.
Green – – to hook to the 12 volt power source – – this wire is pre-connected
to the green Genie indicator lamp on the dashboard end of the cable
Blue – – to hook to the pump motor switch (RGS) – – this wire is
pre-connected to the yellow Genie indicator lamp on the dashboard end of the
cable
All four colors are already hooked up to the appropriate places inside the
Genie Lamp display module. Your job will be to route the cable to the
appropriate locations and make the four necessary connections.
The cable needs to be routed in such a fashion as to avoid sharp edges or
high heat – – either of which could damage the insulation and cause failure
of the Genie Lamp accessory. Use of wire ties, additional protective
sheathing, tape etc., may help in this regard.
More specific connection info can be found in the data sheet called THE
IMPROVED THREE LIGHT GENIE LAMP ACCESSORY.
Contact oldusedbear if you need us to email you a copy
